Whittier Wood Products 499W Instrucciones Para Armar página 6

FIG. 8
8. Attach the Crown Moulding (I) and Base (J) by sliding the Rafi x Bolts into the Rafi x Cams.
Tighten the cams. See FIGURE 8.
FIG. 9
P
P
P
SQUARE THE TOP SECTION:
9. With the unit laying face down on a protective surface, measure from top left of unit to right
corner of Center Shelf (
/
( ). Measurements should be equal. If line (
until measurements are equal. If line (
FIGURE 9.
Fasten the Upper Back Panel (K) to the unit through the pre-drilled holes in the back panel
using the #6 x 5/8" Philtruss Screw (P). Line up fl ush to top of Top Shelf and centered side to
side. Be careful not to over-tighten the screws as you might strip the wood.
PAGE 6 – 498W & 499W
All manuals and user guides at all-guides.com
P
P
P
P
P
P
P
/
) and from bottom left corner of Center Shelf to top right of unit
P
P
P
P
/
) is longer, tap left corner of Center Shelf
/
) is longer, tap right corner of Center Shelf. See
x14
(498W)
P
x16
(499W)