Brinkmann Home Security SL-8 Manual Del Propietário página 6

All manuals and user guides at all-guides.com
INSTR-821-7100-0_SL7_Span.qxd
TESTING INSTRUCTIONS
Step 1
After installing your light, leave the switch in
the "OFF" position and charge in FULL,
DIRECT SUNLIGHT for THREE FULL SUNNY
DAYS.
Step 2
After allowing the battery to fully charge, the
motion detector can be adjusted and tested.
Point the motion detector head down 15°
from horizontal level.
Step 3
Rotate the switch to "TEST" position. Turn
the range knob all the way to the minimum
setting (counter-clockwise). The light will
come on for a few seconds, then turn off.
Step 4
Wait one minute for the circuit to stabilize,
then walk slowly across the detection zone.
The light will turn on as soon as your
presence is detected. The light will turn off
in approximately 10 seconds after motion
stops or you leave the detection zone.
Adjust the detector head up or down, left or
right, in small increments as necessary.
Increase the range by turning the knob
clockwise a little at a time and only if
necessary. Most applications work best at
the lower range setting.
5
6/25/07 2:56 PM Page 6
90°
75 Feet