Indicator Lights - Uline Tork H-5806 Instrucciones De Instalación

OPERATION
• This dispenser is not suitable for installation outdoors
or in wet environments.
• It is not water resistant. Under no circumstances
should the dispenser be hosed down.
• To ensure proper function, the dispenser must be
installed in an environment with minimum and
maximum ambient temperatures between
41 - 86º F (5 - 30º C) and should acclimate at these
temperatures for 24 hours prior to installation.
• Dispenser shall be powered with three D-type alkaline
batteries. Do not use rechargeable batteries. For
optimal performance, batteries should be stored at
temperatures between 41 - 86º F (5 - 30º C).
• An optional manufacturer-supplied plug-in power
supply is available. This accessory must be installed
according to provided instructions. Failure to use the
manufacturer's power supply, or to follow instructions,
presents a risk of electrical shock and may result in
destruction of the dispenser, its software, and presents
significant risk of injury or property damage. Operating
sound level of the dispenser is less than 70 dBa.

INDICATOR LIGHTS

The low roll indicator light will begin to blink yellow when
the roll is thin enough in diameter to be used as a stub
roll (if desired). It will continue to blink until the dispenser
is loaded with a new roll. (See Figure 16)
PUSH
Figure 16
The low battery indicator light will begin to blink red
when the battery power is low. Replace the batteries
soon if indicator light is blinking. (See Figure 17)
PUSH
Figure 17
PAGE 4 OF 17
OPERATION AND FEATURES
Low Roll
PUSH
Low Battery
PUSH
MANUAL FEED
Use the paper feed button to check for proper battery
installation, as well as to feed the tail of the paper into
the roller. (See Figure 18)
PUSH
Figure 18
SHEET LENGTH
Sheet length can be adjusted from a minimum of 8" to
a maximum of 18". Push button appropriate number of
times for sheet size you desire. Push 1x = 8" sheet,
2x = 10" sheet, 3x = 14" sheet, 4x = 18" sheet. (See Figure 19)
Sheet
Length
Figure 19
HAND SENSOR
Hand sensor comes pre-set to "on." This means that the
user is required to wave a hand in front of the sensor to
dispense a towel. To set the sensor to "off," push button
and hold down for five seconds until light on hand
symbol turns off. This means that towels will automatically
dispense each time a sheet is taken. (See Figure 20)
Hold 5 Seconds
Figure 20
PUSH
PUSH
Sensor On
Sensor Off
0721 IH-5806