Rotor 2Inpower Training Use - ROTOR 2 IN PUWER Manual De Usuario

7. ROTOR 2INpower TRAINING USE

After pairing ROTOR 2INpower, follow the configuration options for your computer device to
select the metrics you would like to display on your device.
Consult your personal trainer in order to evaluate which of the measured values provided by ROTOR
2INpower are optimal to maximize your performance.
ROTOR 2INpower MEASUREMENT
ROTOR 2INpower starts measuring data automatically when pedaling. The following data are
sent by radio signal to your head unit:
POWER: power of the last complete pedal cycle. The power displayed on your computer device
is the sum of the power measured for each leg.
BALANCE: gives the information about how much power is applied by each leg. It is shown as
two complementary percentages. This balance number is not an estimate but a real value, as
2INpower takes into account the complete pedal stroke (positive and negative force applied by
each leg) for its calculation.
CADENCE: measured in RPM's (revolutions per minute).
Remove any cadence sensor from your bike, it is not necessary and may cause interference.
Turn off the cadence sensor on the monitor; this will be displayed thanks to 2INpower.
TORQUE EFFECTIVENESS: used to
interpret how much negative force is
exerted by pedaling, its value being
the ratio between the total torque
delivered and the positive torque.
PEDAL SMOOTHNESS: used to
interpret if the pedal stroke is rounder or more piston-like, its value being the ratio between the
total torque and the maximum torque of each cycle.
WARNING!
ROTOR 2INpower training use 45