Equipment Assembly - Tramontina AP1000T Manual De Uso Y Mantenimiento

• Read the instructions carefully. Operators should be familiar with the controls and the proper
use of the equipment.
• Use the trimmer with the protector (protective skirt) always. The protector is a safety device for
the operator. In the protector, the cutting blade is fixed that limits the length of the nylon string,
preventing overload and consequent burning of the motor.
• The use of the equipment without the protective skirt, as well as, the nylon string outside of the
recommended diameter, is considered as warranty loss.
• Before turning on the equipment, check if the trimmer's electric tension is set in accordance with
the local electric tension.
Protector - Fig. 01, page 03
Mount the shield (2) on the frame (1) by pushing the three pins into the shield on the frame and
attaching it with the three screws (3).
Puller - Fig. 02, page 03
Attach the puller (4) to the grip (5), observing the curvature as pictured. Adjust the desired angle and
insert the screw (6) in the puller (4). Position the knob (7) on the other side and push them together
until firm. The screw may go on either the left or right side.
Puller settings - Fig. 02 and 03, page 03
To adjust the puller (4) position, loosen the knob (7), set to the desired position, and tighten the knob
(7) again.
Using the equipment without the shield (debris guard) will void the warranty.
Before using the equipment, read carefully the usage and maintenance manual.
Before turning on the equipment, check if the trimmer's electric tension is set in accordance with the local
electrical tension.
For your security and to prevent the electric cable from being disconnected from the plug while the work
is being executed, bend the cable (1) and pass it through the opening (2), [Fig. 04 , page 04], then fit it
in the clamp (3), [Fig. 05, page 04], only then connect the electric cable to the plug of the grass trimmer.
The trimmer must be used with both hands. Secure the grip with one hand and the handle with the
other.
Keep the switch pressed down constantly during the work, avoiding oscillations of the rotation of the motor.
WARNING

EQUIPMENT ASSEMBLY

OPERATION AND FORM OF USAGE
12
EN