Idiomas disponibles
Idiomas disponibles
4
Scope of supply
1x hand brake lever (preassembled)
Assembly
- Remove screw
with lock nut
- Remove the original hand brake lever.
- Press out sleeve
from original hand brake lever using a suitable
tool.
- Remove brake light switch actuator
- Position brake light switch actuator
brake lever
(included).
- Mount sleeve
using a suitable tool.
- Position hand brake lever
Thrust pin is correctly mounted on the sleeve.
- Mount screw
with lock nut
- Tighten screw
to 6 Nm.
NOTE
The distance between the handle and hand brake lever can be
adjusted to the size of your hand by turning adjusting wheel
The range of adjustment is limited!
Turn the adjusting screw by hand only, and do not apply any
force. Do not make any adjustments while riding!
Adjusting the lever length:
- Loosen screw
.
- Move handle
into the desired position.
- Tighten screw
.
Ensure that the lever is assembled correctly. Check that the
brake is functioning correctly before using it for the fi rst time!
.
with thrust pin.
with thrust pin on the hand
.
and tighten to 6 Nm.
.
