Promise Technology Vess R2000 Serie Guia De Inicio Rapido página 13

To install the Vess R2600 subsystem or Vess J2600 expansion into a rack with the supplied
mounting rails:
1. Check the fit of the mounting rails in your rack system.
2. Adjust the length of the mounting rails as needed.
• The rear rail slides inside the front rail. The rail halves are riveted together and use no
adjustment screws.
• The front-left and front-right mounting rail ends are labeled.
• Be sure the front rail support is on the bottom facing inward.
Figure 8: Installing the rails onto the rack
Front left label
Support flange on the front end of
each rail
• All rail ends, front and rear, attach at the outside of the rack posts.
• The guide pins at the rail ends align with the holes in the rack posts.
• Use the attaching screws and flange nuts from your rack system. Tighten the screws and
nuts according to instructions for your rack system.
All manuals and user guides at all-guides.com
Front right label
Guide pins on rails align with holes in
11
the rack post