Connecting A Monitor - Toshiba dynadock V Manual Del Usuario

Setting Up the dynadock™ and Connecting Peripherals
NOTE

Connecting a monitor

You can connect a digital (DVI) or analog (VGA) monitor to the
dynadock™. Only one monitor can be connected to the dynadock™
at a time.
To connect a monitor to the dynadock™:
1 If you are connecting a VGA monitor, attach the DVI-I to VGA
adaptor (included with the dynadock™) to the DVI-I video
port on the dynadock™.
2 Connect the monitor cable (not provided) to the DVI-I video
port on the dynadock™ or to the adaptor you connected in
step 1.
3 Connect the other end of the cable to the external monitor.
NOTE
To adjust to Extended mode or Mirror mode, see
video settings" on page
NOTE
NOTE
You can customize the video settings of the dynadock™. See
"Adjusting video settings" on page 32
The dynadock's Network port does not support Wake-up-on-LAN.
The Local Area Connection icon in the system tray/notification area
®
of your Windows
"Network Connections" to view the Ethernet Connection.
The monitor cable can be connected/disconnected at any time
without disconnecting the dynadock™ from your computer.
Extended mode is not available on all versions of Windows
Starter Edition.
If no output is seen on the monitor connected to the dynadock™, the
current video resolution setting may not be supported by the
monitor. This can happen if the monitor does not report its supported
modes to the dynadock's DVI component. Adjust the resolution of the
external monitor until an image is shown. For more information, see
"Using the TOSHIBA Video Dock Utility" on page
Connecting your peripherals
desktop will not show a connection. Open
32.
for more information.
23
"Adjusting
®
7
29.