Using Accessories; Notes On The Use Of This Ironer - Miele professional PRI318 Instrucciones De Uso

Ocultar thumbs Ver también para PRI318:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 68
Always supervise any children in the vicinity of the flatwork ironer. Never allow children
to play with the flatwork ironer.
While the flatwork ironer is switched on and heated, there is a risk of burning if the edge
of the heater plate on the laundry output side is touched.
Do not set the ironing temperature higher than the temperature given on the care label of
the laundry item you intend to iron. The laundry could ignite if the ironing temperature is set
too high.
When ironing double-layered laundry items, do not put your hands between the layers
when trying to stretch the item. There is a danger that you do not move your hands out of
the way of the hot heater plate in time. This also applies to inserting your hands in pockets
whose open sides are facing the hot heater plate.
The flexible laundry feed mechanism for reverse laundry removal (optional) may only be
turned from the front.
Do not iron items with fringes, thin ties and straps, etc. on flatwork ironers with feed-in
belts. These could get tangled in the feed-in belts and cause a fault.
While using the ironer, keep your hands away from the areas between the side columns
and the roller. There is a danger of squashing your fingers in the rotating roller.
Ensure the room in which the flatwork ironer is being used is sufficiently lit.
The flatwork ironer must be switched off when not in use.
Keep the working area around the flatwork ironer free from clutter.
Make sure that a fire extinguisher is in the direct vicinity and can be used at any time.
There is a risk of fire if the ironing temperature is set too high, the laundry is not suitable for
ironing or the laundry was not cleaned in water!
The installation of the flatwork ironer in non-stationary locations (for example, on ships)
may be performed only by specialised companies/specialists if they can guarantee the
prerequisites for the safe use of the flatwork ironer.
The country-specific safety regulations and provisions, as well as standards, must be
taken into consideration.

Using accessories

Accessory parts may only be fitted when expressly approved by Miele. Using spare
parts or accessories from other manufacturers will invalidate the warranty, and Miele can-
not accept liability.

Notes on the use of this ironer

Only responsible people over the age of 16 years who have been fully trained in the use
of the ironer should use the infeed table.
When working with the ironer, always wear close fitting clothes and keep long hair tied
back. Wide sleeves, apron straps, scarves and ties etc. could be taken in by the roller.
Remove rings and bracelets before ironing.
en - Warning and Safety instructions
27
Tabla de contenido
loading

Este manual también es adecuado para:

Pri418Pri421

Tabla de contenido