Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CYCLONE SYSTEM
ALIGNMENT TOOL
8.912-854.0
STEP 1:
Disconnect water to Cyclone, then turn
entire machine over to allow access to
nozzle jets.
STEP 3:
Use either the 20° or the 15° end of tool, adjust nozzle to align with angled
surface of tool. NOTE: 20° is the factory setting. Nozzles can be set at 15° if
a slower rotational speed is desired.
8.914-338.0 • Rev. 11/12
Alignment
Tool
Axle
Plastic Body
15°
OPERATOR'S MANUAL
Nozzle Arm
STEP 2:
Place base of alignment tool flat against
bottom of Cyclone plastic body. Press end
of tool (opposite of desired angle) against
axle, then rotate nozzle arm to alignment
tool as shown.
20°
5
Tabla de contenido
