Idiomas disponibles
Idiomas disponibles
EN
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance. We recommend that
our agent or qualified technician clean the clean the condenser.
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to
your retailer.
Fault
The appliance is
not working
The appliance
turns on, but the
temperature is
too high/low
The appliance is
leaking water
The appliance is
unusually loud
18
Probable Cause
The unit is not switch on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Too much ice on the
evaporator
Condenser blocked with dust Call your agent or qualified technician
Doors are not shut properly
Appliance is located near a
heat source or air flow to the
condenser is being
interrupted
Ambient temperature is too
high
Unsuitable foodstuffs are
being stored in the appliance
Appliance is overloaded
The appliance is not properly
levelled
The discharge outside is
blocked
Movement of water to the
drain is obstructed
The water container is
damaged
The drip tray is over flowing Empty the drip tray(if applicable)
Loose nut/screw
The appliance has not been
installed in a level or stable
position
Action
Check the unit is plugged in correctly and
switched on
Call your agent or qualified technician
Replace the fuse
Check power supply
Call your agent or qualified technician
Defrost the appliance
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to the fan
Reduce the amount of food stored in the
appliance
Adjust the screw feet to level the appliance
(If applicable)
Clear the discharge outlet
Clear the floor of the appliance (if
applicable)
Call your agent or qualified technician
Check and tighten all nuts and screws
Check installation position and change if
necessary
