Multiplex ROXXY 900 Serie Manual De Uso página 17

10. Reverse function (Boat and Car modes only)
In Boat or Car mode the Reverse function is used for se-
lecting whether the motor works only in one direction of ro-
tation, or in forward and reverse. In "One Way" mode (only
one direction of rotation) the motor's direction of rotation can
also be selected: the two options are forward and reverse. In
"Two Way" mode the speed controller is set up for forward /
reverse operation.
Caution: changing the direction or motor rotation may cause
the cancellation of other settings.
11. Governor Response - Helicopter mode only
This mode is used for setting the characteristics of the speed
controller in speed governor (regulator) mode. The available
options are Slowest / Slow / Normal / Fast / Fastest.
Caution: the faster the value you select, the higher the current
drawn from the battery. We recommend that you select a fairly
low setting in order to avoid premature damage to the speed
controller and/or the l ight battery.
12. Governor On / Off - Helicopter mode only
This mode is used for switching speed governor (regulator)
operation on and off. Governor mode stabilises the pre-set
rotational speed and keeps it virtually constant. The options
are: "On" mode for stabilised, or "Off" mode for non-stabilised.
13. Motor Pole Number
In Motor Pole Number mode you can enter the number of
poles in your motor. This value is important for indicating the
exact rotational speed. The available range extends from 2 to
36 poles.
www.modellmarkt24.ch www.modellmarkt24.ch
14. Gear Ratio
This mode allows you to enter the individual gearbox ratio you
are using. The value for rotational speed indication is calculat-
ed using the number of motor poles and the gearbox reduction
ratio. The available range of values is from 1.0 : 1 to 25.0 : 1.
15. Max. RPM & Average RPM
This mode shows you the maximum and average rotational
speeds recorded during the last l ight, taking into account the
values set under Points 14 and 15.
16. Down Load
Download mode is used for writing (transferring) set values to
the speed controller. Press the INC button to start the process,
and the Programmer then beeps once every second until the
procedure is complete. If you wish to interrupt the process,
simply press the DEC button.
17. Restore Memory
Restore Memory is used to access values which have been
stored in the Programmer's own memory. Press the INC button
to start the process, and the Programmer then beeps once
every second until the procedure is complete. If you wish to
interrupt the process, simply press the DEC button.
18. Backup Memory
Backup Memory mode allows you to store permanently the
selected values in the Programmer's integral memory. Press
the INC button to start the process, and the Programmer then
beeps once every second until the procedure is complete. The
values set on the speed controller itself are not affected by
this action. If you wish to interrupt the process, simply press
the DEC button.
17