Thank you for buying a Texsport Authentic Adventure Gear product. We hope you enjoy your new
propane appliance and that it will serve you for many years to come. We encourage you to read and
understand each step of the set-up and safety operation instructions prior to working with this propane
appliance.
• NEVER use in an enclosed area.
• DO NOT use heater while sleeping.
• Always use heater in the upright position.
• Always use handle to move heater.
• DO NOT expose the propane tank to excessive heat.
• Never operate heater with missing or damaged parts or mantles.
• Always inspect heater, propane tank and connections for damage, debris or dirt before attaching the
heater to the propane tank.
• Always attach/detach propane cylinder outdoors away from any open flame or pilot lights and only
when the heater is cool.
• When storing or transporting heater, always disconnect the propane tank and store it in a cool, well
ventilated location, in an upright position.
• Be sure connection to propane tank is tightly secure (hand tighten only) prior to each use.
• Never operate the heater near any flammable liquid or vapors. Keep all flammable or combustible
materials beyond the clearance zone as indicated on the back panel of this booklet.
• Discontinue operation and close valve if:
– ambient temperature drops below -10˚ F.
– there is no fuel remaining in the propane cylinder
– combustion becomes unstable
– lighting cannot be performed quickly and easily
– you experience repeated flame outs
• Never leave heater unattended when hot or in use.
• KEEP OUT OF REACH OF CHILDREN.
NOTE: AN IMPACT TO THE REGULATOR AREA COULD
DAMAGE THE REGULATOR AND FAIL TO LIGHT CORRECTLY,
HEATER ASSEMBLY – ASSEMBLE OUTDOORS
Step 1 .........Use only propane bulk tanks approved for use by the United States
Department of Transportation.
Step 2 .........Remove plastic protector cap from valve adapter connection.
Step 3 .........Make sure that the heater/control valve knob is turned off. Twist in a
clockwise direction.
Step 4 .........Make sure heater valve adapter rubber seal is clean and undamaged.
Step 5 .........Be certain the POL adapter is undamaged rubber seal is clean and
undamaged.
Step 6 .........Screw POL adapter directly onto bulk tank fitting counter clockwise.
(hand tighten only)
2E
FOR OUTDOOR USE ONLY
GENERAL SAFETY INFORMATION
RESULTING IN MELTING PARTS.
