Disposal; Troubleshooting - RIDGID micro LM-100 Manual Del Usuario

• Contact Ridge Tool Technical Services Department at rtctechser-
[email protected], or in the U.S. and Canada call (800) 519-
3456.
For troubleshooting suggestions, please refer to the troubleshoot-
ing guide on page 13.

Disposal

Parts of the micro LM-100 Laser Distance Meter contain valuable
materials and can be recycled. There are companies that special-
ize in recycling that may be found locally. Dispose of the com-
ponents in compliance with all applicable regulations. Contact your
local waste management authority for more information.
Troubleshooting - Error Codes
CODE
204
208
209
252
253
255
CAUSE
Calculation error.
Received signal too weak, measurement time too
long, Distance >50m.
Received signal too strong. Target too reflective.
Temperature too high.
Temperature too low.
Hardware error.
micro LM-100 Laser Distance Meter
For EC Countries: Do not dispose of electrical equip-
ment with household waste!
According to the European Guideline 2002/96/EC for
Waste Electrical and Electronic Equipment and its imple-
mentation into national legislation, electrical equipment
that is no longer usable must be collected separately and disposed
of in an environmentally correct manner.
Battery Disposal
For EC countries: Defective or used batteries must be recycled ac-
cording to the guideline 2006/66/EEC.
Ridge Tool Company
CORRECTIVE MEASURE
Repeat procedure.
Use target plate.
Use a commercially available target plate.
Cool down instrument.
Warm up instrument.
Power the unit OFF then ON, if the symbol still ap-
pears, please contact technical support.
13