easyGO extreme Manual Del Usuario página 11

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
1.Seat installation for group II (children
weighing 15 -25 kg) and group III (children
weighing 22 – 36 kg) with 3-point car seat
belt or simultaneously with ISOFIX system.
WARNING! Always install the seat with a
3-point car seat belt. Never install it with
ISOFIX connectors alone as they are only for
additional stability. You can install the seat with
a 3-point car seat belt alone without ISOFIX
connectors.
Rotate the levers releasing the ISOFIX
connectors in the direction of the arrow and
pull out the ISOFIX connectors completely.
Make sure that they are locked and will not
move on their own. Next, push the connectors
against the passenger seat attachment points
and press to hear a characteristic "click".
Rotate the levers releasing the connectors
again and simultaneously push the seat into
the backrest. Rotate the levers back to the
initial position and pull the seat gently towards
you to make sure that it is installed correctly
(fig. 1).
WARNING! If you are installing the seat with
3-point safety belt alone, the ISOFIX cannot
be pulled out.
Lead the shoulder strap through the shoulder
strap guide under the seat's headrest and the
lap strap under the armrest (fig. 2A). Place
your child in the seat and connect the belt to
the appropriate buckle (fig. 2B).
Adjust the backrest and headrest height by
pulling the lever behind the seat's headrest
(fig. 3). Adjust the height to have the shoulder
strap running halfway between the child's
shoulders and neck. Make sure that the lap
strap is running under the seat's armrests
(fig. 4).
2.Taking the car seat out of the car.
Unbuckle the belt and slide it out of the seat's
runners.
If the seat is installed with ISOFIX connectors,
push the connector release buttons (fig. 5).
You should hear a characteristic "click" when
the connectors are released.
3.Upholstery removal.
WARNING! Never use the seat without the
upholstery.
In first order, remove the upholstery from the
headrest and upper backrest (fig. 6). Next,
remove the upholstery from the side covers
(fig. 7). Before removing the upholstery from
the base, recline the backrest to maximum,
and disconnect the backrest from the base
(fig. 8). Now you can remove the upholstery
from the base (fig. 9).
To put the upholstery back in place, perform
the actions presented above in reverse order.
11
Tabla de contenido
loading

Tabla de contenido