Idiomas disponibles
Idiomas disponibles
3. If equipped with ground effects, remove the forward rivet from the rocker panel molding. Remove the front wheel opening
rear molding fastener (5) and remove the front wheel opening rear molding (4). Remove the front wheelhouse liner fasteners
(3). Remove the front wheelhouse liner fasteners (1). Remove the front wheelhouse liner fasteners (6) and remove the front
wheelhouse liner (2).
4. Install Front Brake Cooling Duct - there is an attachment on the back of the front bumper beam as long as an attachment point
on the side of the lower radiator protection bar. Hold the duct in place as you tighten the 2 bolts to 9Nm (80lb in).
5. Install the Front Rotor Cooling Duct deflector - these deflectors are mounted to the front control arms. There are 4 fasteners
(1) that are tightened to 4Nm (35lb in).
Front Brake Duct
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
23383593
IR 03JN15
PART NO.
DATE
03JN15
Initial Release - John Kalbfell
2
SHEET
REVISION
10
OF
AUTH
2425899
