Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

__________________________________________________________________________________________________
Front Leveling Kit
Parts Included with Accessory Kit
Description
Lower Spring Spacer
Upper Spacer
Low Profile M10 Nut
Performance Emblem
Instruction sheet
Warning: This kit is not compatible with ZR2, 2WD, or 20"
wheels
Special Tools
·
EN-45059 Torque Angle Meter
·
CH–48845 Strut Spring Compressor
·
CH-43631 Ball Joint Separator
Equivalent regional tools:
Removal Procedure
1. Raise and support the vehicle. Refer to "Lifting and Jacking"
in the vehicle service manual.
2. Remove the front tire and wheel assemblies.
3. Remove the four underbody splash shield fasteners(1) and
underbody splash shield(2).
Note: Rest the front stabilizer shaft on a suitable support to
relieve the tension on the front stabilizer shaft links.
4. Remove both front stabilizer shaft link nuts(1), washers(2),
and spacers(3).
Front Leveling Kit
ALL INFORMATION WITHIN ABOVE
Date
BORDER TO BE PRINTED EXACTLY
14OC19
AS SHOWN ON 8.5 x 11 WHITE 16
POUND NON-BOND RECYCLABLE
PAPER. PRINT ON BOTH SIDES,
EXCLUDING TEMPLATES. TO BE
UNITIZED IN ACCORDANCE WITH
GMCCA SPECIFICATIONS.
Quantity
2
2
6
1
1
Special Tools
Revision
Init Rel – Kevin Loughlin
5. Remove both front stabilizer shaft link bolts(1), washers(2),
and spacers(3) and remove the stabilizer links.
6. Remove the front stabilizer shaft bolts(1), clamps(2) and
stabilizer shaft.
7. Remove outer tie rod nut(1) and separate outer tie rod(3)
from steering knuckle(2).
PART No.
84608731
IR 14OC19
Auth
DR
Title
2974375
PART No.
SHEET
1 of 12
Installation Instructions
Front Leveling Kit
84608731
SHEET 1 of 12
loading

Resumen de contenidos para GM 84608731

  • Página 9 (3) del estabilizador delantero. de la articulación de dirección (2). PART No. SHEET 84608731 9 of 12 Front Leveling Kit IR 14OC19 ALL INFORMATION WITHIN ABOVE Date...
  • Página 10 Nota: Es posible que el rotor tenga que girarse hacia afuera para dejar espacio para que pase el amortiguador 10. Retire el amortiguador delantero y el ensamble de resorte (1) del vehículo. PART No. SHEET 84608731 10 of 12 Front Leveling Kit IR 14OC19 ALL INFORMATION WITHIN ABOVE Date...
  • Página 11 (1) en el vehículo. 5. Apriete la tuerca de espiga a 38 Nm (28 lbs pie). 6. Libere la presión en el compresor de resorte y retire. PART No. SHEET 84608731 11 of 12 Front Leveling Kit IR 14OC19 ALL INFORMATION WITHIN ABOVE...
  • Página 12 11. Utilice el EN-45059 medidor para apretar el perno del soporte inferior del amortiguador delantero(1). a. Apriete: i. Primer pase: 100 Nm (74 lbs pie) ii. Pase final: (25–35 grados) PART No. SHEET 84608731 12 of 12 Front Leveling Kit IR 14OC19 ALL INFORMATION WITHIN ABOVE Date Revision...