DeWalt D24001 Manual De Instrucciones

Fig. A
Fig. B
Fig. C
The following are trademarks for one or more D
configuration, and the array of lozenge-shaped humps on the surface of the tool.
D WALT Industrial Tool Co., 701 East Joppa Road, Towson, MD 21286
e
(FEB19) Part No. N686262 D24001
WALT power tools: the yellow and black color scheme, the "D" shaped air intake grill, the array of pyramids on the handgrip, the kit box
e
HEAVY DUTY TILE SAW STAND
D24001
This Tile Saw Stand is designed for use with the D24000 Wet Tile Saw. Do not use this saw
stand with any other tool.

WARNING: For your own safety, read the tool instruction manual before using any
accessory. Failure to heed these warnings may result in personal injury and serious
damage to the tool and the accessory. When servicing this tool, use only identical
replacement parts.
READ INSTRUCTIONS BEFORE USE

WARNING:
• Read tool and stand instruction manuals before use.
• For use with D24000 Wet Tile Saw.
• Open stand fully before use.
• Maximum load: 300lbs. (136kg)
• Do not climb, sit or stand on saw stand.
• Do not use stand on uneven or unstable surface.
• Assemble stand as shown in Figure A.
TO ADJUST TILE SAW STAND
1. The leg extensions each have a series of holes to allow multiple stand heights.
2. Adjust the height of the stand then use fasteners to secure leg extensions. Ensure that
each extension is adjusted to the same height.
TO USE TILE SAW STAND
1. Unfold the saw stand until it is fully opened. Place it upright, as shown in Figure B.
2. Place the Wet Tile Saw pan on the stand. The rear feet on the pan have two semi-
circular reliefs; place these over the rear rail as shown in Figure C. The front rail should
rest behind the front feet on the pan.
TO CLOSE TILE SAW STAND
1. Remove the Wet Tile Saw from the stand.
2. Pick the stand up by the top rails and fold in to close.
Copyright © 2004, 2019 D WALT
e
Rear Pan Feet
Pieds Arrieres du Plateau
Parte Inferior Trasera