Firman P08004 El Manual Del Propietario página 43

Ocultar thumbs Ver también para P08004:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Engine is running, but no
AC output is available.
Engine runs good at no-
load but "bogs down"
when loads are connected.
Engine will not start;
starts and runs rough or
shuts down when
running.
Engine lacks power.
Engine"hunts"or falters.
English
FIRMAN1Page 23
1. Circuit breaker is open.
2. Fault in generator.
3. Poor connection or defective cord set.
4. Connected device is bad.
1. Short circuit in a connected load.
2. Engine speed is too slow.
3. Generator is overloaded.
4. Shorted generator circuit.
5. Clogged or dirty fuel filter.
1. Engine switch set to OFF (O)
position.
2. Fuel shutoff lever is in OFF (O)
position.
3. Low oil level.
4. Dirty air cleaner.
5. Out of fuel.
6. Stale fuel.
7. Spark plug wire not connected to
spark plug.
8. Bad spark plug.
9. Water in fuel.
10. Flooded.
11. Excessively rich fuel mixture.
12. Intake valve stuck open or closed.
13. Engine has lost compression.
14. Clogged or dirty fuel filter.
15. Starting battery may have in
sufficient
charge.
1. Load is too high.
2. Dirty air filter.
3. Clogged or dirty fuel filter.
4. Clogged spark arrester.
1. Carburetor is running too rich or too
lean.
2. Clogged or dirty fuel filter.
1. Reset circuit breaker.
2. Contact authorized service facility.
3. Check and repair.
4. Connect another device that is in
good condition.
1. Disconnect shorted electrical load.
2. Contact authorized service facility.
3. See Don't Overload Generator
4. Contact authorized service facility.
5. Clean or replace fuel filter.
1. Set engine switch to ON (l) position.
2. Move fuel shutoff lever to ON (l)
position.
3. Fill crankcase to proper level or
place generator on level surface.
4. Clean or replace air cleaner.
5. Fill fuel tank.
6. Drain fuel tank and carburetor; fill
with fresh fuel.
7. Connect wire to spark plug.
8. Replace spark plug.
9. Drain gas tank and carburetor; fill
with fresh fuel.
10. Wait 5 minutes and re-crank engine.
11. Contact authorized service facility.
12. Contact authorized service facility.
13. Contact authorized service facility.
14. Clean or replace fuel filter.
15. Check battery output and charge
battery as necessary.
1. Don't Overload Generator 2.
Replace air filter.
3. Clean or replace fuel filter.
4. Clean or replace spark arrester.
1. Contact authorized service facility.
2. Clean or replace fuel filter.
Customer Service: 1-844-
Tabla de contenido

Solución de problemas

loading

Tabla de contenido