Premier NV-5365 Manual De Instrucciones página 22

refrigerator or other place easy to be touched by children.
*Warning-Keep ventilation openings in the appliance enclosure or in the structure for building in, clear of
obstruction.
*Warning-Do not use mechanical devices or other means to accelerate the defrosting process, other
than those recommended by the manufacturer.
*Warning-Do not damage the refrigerant circuit.
*Warning-Do not use electrical appliances inside the food storage of the appliance unless they are of the
type recommended by the manufacturer.
*If the appliance can not be used any more, please release the refrigerant before abandon at a place
exposed to the air and away from tinderbox.
The appliance must be positioned so that the plug is accessible.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
Please dispose the appliance according to the local rule for the blowing gases.
General Instructions for Care and Maintenance
The refrigerator should be cleaned every other month. Before cleaning, the electric plug must be
removed from the power supply.
Wipe the inside and outside of the refrigerator with a wet soft cloth.
If it's too dirty, clean with a soft cloth soaked with neutral detergent and
clean water, remove the moisture with dry cloth.
If you are going away on holiday or for any other reason, wish to leave the refrigerator idle for any period
of time, proceed as follows:
*Disconnect the refrigerator from the electric power supply by removing the plug from the wall socket.
*Remove all food.
*Clean and dry the inside as instructed in the direction given above for cleaning.
*Leave the doors open to prevent any unpleasant smells from building up while the refrigerator is not
used.
Cleaning:
*When cleaning the refrigerator the electric plug must be removed from the power supply.
*Use water and a non abrasive detergent.
*Clean with a soft cloth soaked in this solution and remove moisture with a dry cloth.
*Remember to clear the defrost drain situated at the back just above the glass cover.
Replacing the light bulb
Should the light fail, switch off at the socket outlet and pull out the mains plug. Then ensure the bulb is
screwed securely in the bulb holder. Replace the plug and switch on. If the light still fails, obtain a
replacement E14 screw-cap type 15 Walt (Max) bulb from your local electrical sore and then fit it.
Carefully dispose of the burnt-out light bulb immediately.
Working Defects and Failures
Symptom:
Appliance will not work at all.
Cause:
P-5