•
Always begin with the master faders, volume controls and the amplifier volume at minimum position.
Gradually turn up the volume after connection is completed.
•
Use the controls with restraint. Rapid movements may damage the speakers due to amplifier clipping.
•
Use the original packaging if the device is to be transported.
•
Keep this manual for future reference.
4. Features
•
outputs: 2 Master (XLR and RCA), 1 Rec (RCA) and booth monitor output (RCA)
•
inputs: 2 Phono (RCA), 4 Line (RCA) and 1 MIC (Combi), USB
•
with Digital Signal Processor (DSP) effects and fader start control
•
trim: gain for each input channel
•
peak level meter: allows the user to instantly determine the source input condition for each channel
•
talk over: mutes -14dB all levels apart from the microphone MIC1
•
cross fader curve: choose from two types of cross fader start-up options
•
headphone monitor balance between cue and master out
•
freely assignable long life TCT cross fader (45mm) with adjustable curve
•
extra LED display per channel for pre-listening signal
•
gain control with 3-fold sound control (+12/-26dB) per channel
•
3-fold sound control (+12/-26dB) for microphone
•
CUE on and off switch for each channel
•
cue-split function: the cue signal is sent to one side of the headphones and the output-signal to the
other side.
5. Overview
Refer to the illustrations on page 2 of this manual.
1
power switch: turn the mixer on or off.
3-pin XLR connection for main microphone (not included)
2
MIC LEVEL: adjust the microphone input level
HI/LOW: microphone equalizer
Input channel controls (CH-1 ... CH-4)
Input selector switches:
•
Channel 1-2: LINE or PHONO. Set to PHONO if a turntable (not incl.) is connected to the input;
otherwise set to LINE.
•
Channel 3: LINE or USB. Set to USB if an input device is connected via the USB port [24]; otherwise
set to LINE.
3
•
Channel 4: LINE or MIC. Set to MIC if a microphone (not incl.) is connected to the input; otherwise
set to LINE.
TRIM: adjust the input signal level
HI/MID/LOW: channel equalizer
Peak level meter
Master channel
4
LED meter: indicates the master output level
TALK OVER: press this button to decrease the sound level for everything other than the main
5
microphone to 14dB. Press again to restore original status.
CUE: press this button to monitor the channel with headphones. You can select multiple channels at
6
once, including the master channel and the DSP effects. Press again to cancel the selection.
V. 02 – 09/03/2012
All manuals and user guides at all-guides.com
PROMIX400U2
4
©Velleman nv