Preparing The Battery Pack For Recycling - Toro 51484 Manual Del Usuario

1. Spool
Note:
Remove any old string remaining on the spool.
3. The spool accepts up to 4.5 m (15 ft) of string.Use only 1.65
mm (0.065 inch) diameter monofilament string.
Note:
Do not use any other gauge or type of string, as this
could damage the trimmer.
4. Insert the string into the anchor hole in the upper part of
the spool (Figure 14). Wind the string onto the spool in the
direction shown by the arrows on the spool.
5. Place the string in the slot on the upper spool flange, leaving
about 152 mm 6 inch (6 inches) extended beyond the slot.
Note:
Do not overfill. After winding the string, there should
be at least 6 mm 1/4 inch (1/4 inch) between the wound
string and the outside edge of the spool.
6. Replace the spool and the spool retainer. Refer to
the Spool (page 10) earlier in this manual.
Preparing the Battery Pack
for Recycling
Important:
Upon removal, cover the terminals of the
battery pack with heavy-duty adhesive tape. Do not attempt
to destroy or disassemble the battery pack or remove any of
its components. Recycle or properly dispose of lithium-ion
battery packs at a battery recycling facility.
For more information on recycling lithium-ion
battery packs and to locate the battery
recycling facility closest to you, visit
www.Call2Recycle.org (US and Canada only).
If you are located outside of the US and
Canada, please contact your authorized Toro
distributor.
Service
Should this item need service, take the product to your Authorized
Service Dealer.
Figure 14
2. Hole
Storage
•
Clean all foreign material from the product.
•
Store it in a well-ventilated place that is inaccessible to
children.
•
Keep away from corrosive agents such as garden chemicals
and de-icing salts.
Troubleshooting
Using the battery when it is hot can reduce the operating time.
The battery automatically stops working when it is overheated to
prevent damage to it. Remove the battery from the charger and
g015662
allow it to cool before placing it back into the trimmer.
Using the battery when there is moisture on the leads can cause
the trimmer to malfunction. Allow the battery to dry or wipe it dry
before placing it back into the trimmer.
Replacing
11