Operating Instructions; Intended Use; Battery; Charging The Battery - JCB -18BLRH Instrucciones De Funcionamiento

OPERATING INSTRUCTIONS

Intended Use

This rotary hammer drill is intended for drilling
in stone, wood, metal, ceramics and plastics,
percussion drilling in brickwork, concrete and
stone and percussive chiselling in masonry and
plaster.
The tool must not be modified or used for
any other purposes than the ones described in
these instructions.

Battery

NOTE
Make sure the power switch is not pressed
in when inserting or replacing the battery.
Use JCB batteries only: JCB-20LI,
JCB-30LI, JCB-40LI and JCB-50LI.
Do not force the battery when
m
connecting it, use moderate pressure.
An incorrectly connected battery can
damage the battery terminals or the battery
socket on the tool.
Use the button on the battery to check the
m
charging status; 4 red LEDs indicates fully
charged, where 1 indicates low battery
status.

Charging The Battery

WARNING!
After charging for the first time, ensure the
battery is completely discharged before
placing on charge again. Repeat this charging
and discharging cycle 4 to 5 times to ensure
battery is correctly conditioned.
Place the battery charger on a level and
m
stable surface. Plug the charger into a 230 V
power point.
JCB-18BLRH
Instruction & User Manual
Connect the battery to the charger so that it
m
clicks into place.
Refer to the Battery Charge Level table
m
below for battery charger status as indicated
by LED lights.
Unplug the charger from the power point
m
and remove the battery from the charger.
Battery Charge Level
Red Green
Battery Charge Status
LED LED
Charger is connected to
mains power
Connected battery is
charging
Connected battery is fully
charged
Connected battery has a
charging fault
Charger is outside correct
operating temperature
range (<0˚C / >40˚C)
If the LEDs on the charger do not come on
when charging:
Check that the charger's mains adaptor is
m
properly plugged into the power point and
that the charger is switched on
Check that the battery is correctly inserted
m
in the charger

Connecting the battery

Connect the battery to the battery socket
m
on the tool so that it clicks into place.

Removing the battery

Press the battery release button and remove
m
the battery from the tool.
13