Sistem-Air JOLLY Manual De Instalación, Uso Y Mantenimiento página 47

Put the Jolly suction unit into the housing,
position it on the wall and check the correct
perpendicularity with reference to the floor.
Use a pencil and draw the position of the six
holes to be drilled for fixing the suction unit to
the wall.
6
5
N°6
1
4
2
3
Fit the connection sponge (1) in the round
housing (2) around the pipe union of the air
exhaust (3) of the Jolly suction unit.
Fit the extension (4) in the sponge; check that
the cover of the exhaust pipe union is not
obstructed.
NOTE: when installing the suction unit into
thick walls, you probably need to fit more than
one extension; another extension can be
coupled to the first one to obtain the desired
measure.
Plug-in the unit
(see paragraph 4.7)
Jolly-Jolly Contact 01-04/01
Installation, use and maintenance guide
8
Remove the Jolly suction unit from the housing
9
and drill the 6 holes previously sketched.
Drill the holes by paying attention to the type of wall
you are drilling and to the screw anchor to be used.
10
11
17
90° 90°
6
5
1
4
2
3
( 3 )
( 2 )
( 1 )
( 4 )
art. 8510.0