Troubleshooting; Specifications - Sony CDP-XE530 Manual De Instrucciones

Additional Information

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
/ Check that the player is connected securely.
/ Make sure you operate the amplifier correctly.
/ Adjust the output level with LINE OUT LEVEL +/–
on the remote.
The CD does not play.
/ There's no CD inside the player. "- NO DISC -" (or
"no dISC" for the CDP-XE330) appears. Insert a CD.
/ Place the CD with the label side up on the disc tray
correctly.
/ Clean the CD (see page 17).
/ Moisture has condensed inside the player. Remove
the disc and leave the player turned on for about an
hour (see page 2).
The recording level has changed.
/ The recording level changes if you adjust the output
level with LINE OUT LEVEL +/– on the remote
during recording.
The remote does not function.
/ Remove the obstacles in the path of the remote and
the player.
/ Point the remote at the remote sensor g on the player.
/ Replace all the batteries in the remote with new ones
if they are weak.
18 GB

Specifications

Compact disc player
Laser
Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Max 44.6 µW*
Laser output
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response 2 Hz to 20 kHz ± 0.5 dB
Signal-to-noise ratio More than 100 dB
Dynamic range
CDP-XE530: More than 98 dB
CDP-XE330: More than 92 dB
Harmonic distortion CDP-XE530: Less than 0.0045%
CDP-XE330: Less than 0.005%
Channel separation More than 95 dB
Outputs
Maximum
Jack
output
type
level
LINE OUT
Phono 2 V
jacks (at 50 kilohms)
DIGITAL
Optical –18 dBm
OUT
output
(OPTICAL)
connector
PHONES
Stereo 10 mW
(CDP-XE530
phone
only)
jack
General
Power requirements
220 V – 230 V AC, 50/60 Hz
Power consumption CDP-XE530: 11 W
CDP-XE330: 10 W
430 × 110 × 290 mm
Dimensions (approx.)
(17 × 4 3/8 × 11 1/2 in.) incl. projecting
(w/h/d)
parts
Mass (approx.) CDP-XE530: 3.4 kg (7 lbs 8 oz)
CDP-XE330: 3.1 kg (6 lbs 14 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1)
R6 (size AA) batteries (2)
Design and specifications are subject to change without notice.
Load
impedance
Over 10 kilohms
Wave length: 660 nm
32 ohms