Power Indicator - STAMOS POWER2 S-CUTTER 50 Manual De Instrucciones

On
1 On/off switch
Off
2 CURRENT / Current controller: main current is adjustable
3
POWER INDICATOR: This indicator lights up after turning the
machine on.
Overload / Fault LED indicator:
The indicator lights in the following two situations:
4
a) If the machine has malfunctioned and can not be operated.
b) If the cutting device has exceeded the standard working
time the protection mode is initiated and the machine will stop
functioning. This means that the machine is now being cooled in
order to be able to restore temperature control again after the
device has overheated. Therefore the machine is stopped. During
this process, the red warning light on the front panel lights up. In
this case it is not necessary to remove the power plug from the
socket. The ventilation system may be left on in order to enhance
the cooling of the machine. When the red light goes dark, this
means that the temperature is now down to the normal level
and the unit can be put back into operation.
5 LED - Display: Displays the current amperage.
6
Air pressure – the indicator lights when air pressure is lower
7
than 1.8 bar.
EN
Rev. 26.04.2019
26
8 Manometer
Air pressure adjustment knob
9
10
Grounding cable connection
Ports for plasma torch:
The high energy density of the plasma arc enables a high
11
cutting speed with a warp-free cut quality. No special gas is
required and the possibility to use regular air pressure along
with easy handling of the unit are a guarantee of easy use in car
bodies, containers, steel construction, the HVAC industry as
well as in installations and plumbing.
GAS
12
GAS/air connection
AIR
Grounding.
At the back of each welder there is a screw and a label to
13
provide the necessary grounding. Before operating the unit it is
necessary to ground the shell of the welding apparatus by means
of a cable with not less than 6 mm diameter, in order to prevent
MOSFeT
potential problems caused by electricity leakages.
Rev. 26.04.2019
EN
27