LIMIT LDM 80 Manual Del Usuario página 6

1.1 Open the battery cover on the back of device, and place battery according to correct
polarity, then close the battery cover.
GB
1.2 Only 1.5 V AAA alkaline battery is applied to the meter.
1.3 If not used for a long time, please take out the battery to avoid battery corrosion to
meter body.
START THE INSTRUMENT & MENU SETTING
1. Turn on/off the instrument
Under off status, press button
by for measurement.
Under on status, long press button
can also be shut off without any operation for 150 seconds.
2. Sound on/off
Long press button
3. Unit setting
Short press button
There are 6 units for selection:
Length
1 0.000 m
2 0.00 m
3 0.0 in
4 0.00 ft
5 0 1/16 in
6 0'00"1/16
4. Reference point
Press key to change the reference point. There are four reference points: top, screw
at the backside, bottom and the end piece.
LENGTH MEASUREMENT & CALCULATION
1. Single distance measurement
Turn on the laser beam by short press of the button
button again for single measurement of length, then the measured results displayed
in the major display area.
2. Continuous measurement
Long press button
mode. Maximum and Minimum value show on the LCD.
Present result displays in major display area. Short press button
measuring mode.
4
. device and laser get starting simultaneously and stand
to turn on or off the buzzer.
, reset current measurement unit, the default unit is: 0.000 m.
Area Volume
2
0.000 m 0.000 m
2
0.00 m 0.00 m
2
0.00 ft 0.00 ft
2
0.00 ft 0.00 ft
2
0.00 ft 0.00 ft
2
0.00 ft 0.00 ft
funder measuring mode and enter into continuous measuring
for 3 seconds to turn the device off. The device
3
3
3
3
3
3
under measuring mode; Press the
to exit continuous