Troubleshooting; Battery Disposal; Cleaning And Maintenance - Concept VP4360 Manual Del Usuario

EN
CHECKING THE FULLNESS OF DUST CONTAINER
If the suction power of the vacuum cleaner is reduced or the dust container is full, empty it and clean the vacuum cleaner
filter.
MAINTENANCE
It is recommended to empty the dust container and clean the vacuum cleaner filters after each use of the vacuum
cleaner.
EMPTYING THE DUST CONTAINER
1. Disconnect the charger from the mains.
2. Hold the vacuum cleaner down with a dust container.
3. Press the latch to release the dust container.
4. Remove the filter holder and empty the vacuum cleaner dust container.
5. Reverse the procedure to attach the filter holder and the filter and put the dust container back.
CLEANING AND REPLACING THE PERMANENT FILTER
The vacuum cleaner filter can be cleaned by mechanical tapping and cleaning with a soft brush. A much soiled filter
can be washed after this step and cleaned with a soft brush in lukewarm water without detergents.
It is important to let the wet parts dry thoroughly. A wet filter would be depleted by vacuuming!
Do not use a hair dryer for drying!
Note: Wet cleaning can cause more wear on the filter and thereby shortening its life.
• The filter should be cleaned or replaced with visible soiling or when the suction power of the vacuum cleaner drops.
Check it after each use of the vacuum cleaner.
• To avoid damaging the vacuum cleaner, do not use it without a properly fitted filter and filter holder.
• You can purchase a suitable filter type from your dealer or order from the manufacturer.

CLEANING AND MAINTENANCE

Accessories and vacuum cleaner can be cleaned with a damp cloth.
Do not immerse the power cord or the charger in water or any other liquid.
Do not use aggressive substances such as solvents or abrasives for cleaning!
48

TROUBLESHOOTING

The motor is not working.
Reduction of suction power.
Operating time at full charge is
The vacuum cleaner is warming
ACCESSORIES
The following accessories can be purchased for the appliance:
Filter

BATTERY DISPOSAL

The appliance contains a Li-Ion battery. This type of battery contains substances that can damage the environment in
their disintegration. Before disposing of the appliance or replacing the battery, the original battery must be removed
and returned to a suitable collection point.
To remove the battery, open the cover on the bottom of the vacuum cleaner.
VP4360 / VP4370 / VP4380 VP4360 / VP4370 / VP4380
Problem Cause
The battery is discharged.
Filled or clogged dust container.
The filter is clogged
The battery life is over.
less than 1 minute.
Warming up of the vacuum cleaner during operation is normal, it is not
up. a malfunction.
order code 42392245 price according to the valid price list
EN
Remedy
Charge the battery.
Empty and clean the dust container.
Clean or replace the filter.
Replace the battery with a new
one. Contact an authorized service
centre.
49