Idiomas disponibles
Idiomas disponibles
COMBO FLUID EXTRACTOR
Designed for the extraction of all types of engine, transmission and lubricating oils from cars,
motorcycles, marine engines and industrial machinery.
Also suitable for low viscosity fluids such as water.
Operating instructions
1. Park the vehicle on level ground and ensure the vehicle transmission is in "neutral" or
"park" and the parking brake is applied.
2. Start the engine and allow it to run until the normal working temperature is reached, then
turn-off the engine.
3. Select a suitable suction tube from the selection available and insert it through the dip stick
tube until the tube reaches the bottom of the oil pan.
Note: Do not bend the suction tube during the insertion procedure.
4. Connect the main suction tube to the extractor's suction hose.
Connect the hose of the
compressed air supply
here for pneumatic
operation
Select a suitable
suction tube
5. Make sure the function knob on the top of the cover is pushed inwards (suction mode), and
the discharge valve at the back of the unit is pushed upward (suction mode).
6. For the "Manual Operation", raise the pump handle on top of the combo fluid extractor to
its highest point and pump the handle to initiate the vacuum. This will start the extraction
of the oil from the engine. Keep pumping the handle until all of the fluid is extracted or it
reaches the top of the combo fluid extractor.
Note: The vacuum will pressure will drop when the fluid level reaches the top of the unit.
7. For "Pneumatic Operation" using a compressed air supply, connect a compressor or
workshop air supply to the unit. The extraction of the oil from the engine will commence
when the air supply is switched on. Note: the working pressure of the air supply must be
set between 5 - 8 bars. The vacuum pressure will drop when the fluid level reached the top
of the unit.
8. When the extraction is complete, withdraw the suction tube from the engine and wipe
clean.
Note: Take care during extraction, when handling the full extractor and cleaning the suction
hose as the oil may still be HOT! Fill the engine to the specified level with new oil, run the
engine to circulate the new oil and re-check the level.
Pouring Out Waste Fluid
1. Remove the suction hose from the extractor, this will reveal the disposal spout.
2. Pour the fluid out through the spout and in to an appropriate waste container. Note: Always
dispose of waste fluids safely and in accordance with legal and environmental regulations.
9,5 L
Once the suction tube has
been inserted, connect it to
the suction hose
EN
