15 3-Point-Belt / Belt Height Adjustment; Armrest (Option) - ISRI 6860 NTS2 Manual De Instrucciones

For your safety, and for the safety of other drivers, the seat can only be adjusted while seated and when
the vehicle is fully stopped and the hand brake is pulled.
INSTRUCTION MANUAL ISRI 6860/875
3-Point-Belt / Belt Height Adjustment
15
The belt height adjustment enables the adaption of the belt outlet to the body
height of the driver. The Belt height adjustment must be matched to the inclina-
tion of the shoulder adaption.
Press roller on the outside (1) and swing the belt to the desired height (2)
(7 steps possible). After releasing the roller, locking mechanism must engage
hearable.
For adjusting the correct belt height, turn belt retainer in a way that the belt
strap is running over the middle of the shoulder.
Take the buckle latch and pull the belt strap over your shoulder, upper body
and pelvis. Push the buckle latch, hearable engaging, into the buckle.
If you want to release the belt, push the red button at the buckle, take the buck-
le latch and lead the belt back to the rolled - up position.
Make sure to use your seat belt always correctly for the whole duration of your
drive. If you don´t fasten your safety belt or if you don´t fasten it correctly, the
risc of severe injuries increases insists.
Correctly fastened seat belts may abate the severity of injuries in case of acci-
dents, hurling or hard breaking.
Never belt in more than one person per seat belt. Do not fasten anything else
on the passenger seat than the person sitting there on or an accredited and
suitable child seat.
Don't twist the seat belt when fastening.
Make sure that the belt tongue engages correctly and audibly in the belt buck-
le. The belt must stay close to the body.
When unfasten, guide the belt tongue back to the belt exit in the backrest
because an uncontrolled uprolling belt can evoke damages by the belt tongue
or the belt doesn´t roll up centrically, so that the edges of the belt webbing
scrub. The leading of the belt strap is all important for an optimal protective
effect of safety belts.
Don´t lead the belt strap in a way that it runs over breakable objects like mo-
bliles or glasses because this can cause injuries or or damges to the objects.
Don´t clamp the belt strap.
Don´t ever lead the belt anywhere else than over your shoulder and over your
pelvis area.
The belt must run over the middle of the shoulder, never along the neck and
must lay tightly on the upper body.
The belt must cross the pelvis area, tightly in front of the pelvis, never across
the stomach.
Voluminous and loose clothing decreases a correct running of the belt
and by that an optimal function.
Never change the belt´s path by mounting belt strap clamps, belt stop
knobs or the like.
Armrests
16
Optimal adjustment of the armrests to relieve muscles in the spine and back.
●
Enables relaxation of muscles in shoulder and neck area.
●
Reduces the load on the spinal disc in the lower spine area.
●
Adjust the armrest to a position where the elbows lay lightly on it.
Lift up armrest a little and adjust inclination stepless by turning the wheel
at the underneath.
The armrest shall not be used as a method of ascent while entering the
vehicle.
23