Tabla de contenido
English
LED Display in setting mode
Symbol Description
Set slow start time
● Press ▲+▼ during 2 sec., LED
will display [RC].
● Use ▲ or ▼ to increase or
decrease slow start time value
from 0.0 to 9.9 sec.
Set slow start speed level
● Press ▲+▼ during 1 sec. after,
set [RC], LED will display [SP].
● Use ▲or▼ to increase or
decrease slow start speed level
from L0 (100%, Disable) or L1 to
L9 (30%~90%).
Slow start speed level
● When [SP] set to [L1] ~ [L9],
indicate the slow start speed level.
No slow start function
● When [SP] set to [L0] , disable
slow start function.
11/2016
MAINTENANCE INSTRUCTIONS
Maintenance should be performed by qualified
personnel only.
Trouble-shooting
Symbol Description
Over voltage protection
- The tool stops when the operating
voltage is high.
- The tool is disabled during
10 seconds before automatic
recovery.
Over temperature protection
- The tool stops when the operating
temperature is high.
- The tool is disabled during
10 seconds before automatic
recovery.
Stall protection (rehit)
- The tool stops when the motor is
abnormally stalled after start.
- The tool is disabled during
10 seconds before automatic
recovery.
Switch reverse
- The tool stops when the reverse
position changes while the motor
is running.
- Switch reverse button back to
recovery.
Shut off error
- The tool stops when the shut off
signal abnormally appears before
start.
- Check and fix the shut off
mechanism to recovery.
Memory error
- The tool stops when the internal
flash memory fails.
- The tool is disabled during
10 seconds before automatic
recovery.
According to Directive 2012/19/ CE
concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled.
● Contact your Desoutter
representative or consult the website
"www.desouttertools.com" to find out
where you can recycle this product.
5 / 8
6159922540_02
Tabla de contenido
