NovoPress ECO 301 Instrucciones De Servicio página 20

green red Ton Cause
LED LED e
- b 6x • Stop button has been
pressed.
• Power failure
green red Ton Cause
LED LED e
- x 6x Press tool faulty.
- x 6x • Press tool is overloaded.
• Mains voltage too low.
• Dirt or deposits between
jaw levers or in press
profile of press jaw.
To rectify the following faults, always:
- Press Start button (1) until piston is fully retracted.
green red Cause
LED LED
- b Start button released before tool
is ready for automatic pressing
(Zwag).
Fault signal before press tool could start:
NOTE LAST PRESSING (POSSIBLY) NOT OK!
Fault signals after press tool started.
Note THESE PRESSINGS ARE NOT OK!
Remedy
Do not press Stop button unintentionally. Check
fitting for leakage and, if necessary, carry out
pressing once more.
Remedy
Return press tool to Novopress for inspection.
• Use only permitted materials (see "Intended use").
• Should this fault occur repeatedly in succession,
allow the press tool to cool down fully.
• Check mains voltage.
• Clean press jaw.
Remedy
Keep Start button pressed for a prolonged period
(approx. 2 seconds).
14