TRAPP Master 500L Manual De Instrucciones página 28

How to refill the spool
Should you prefer to refill the spool by
yourself:
✔
Only use a nylon line of the diameter
recommended for the model of your
equipment (1.6 mm for Master 500L/600
and 1.8 mm for Master 700/800).
✔
Nylon lines in a diameter other than the
specified may damage the motor and the
automatic advancing system.
✔
Remove the spool and the rest of the nylon
line.
✔
Take one end of the wire and pass it
through hole (1) as shown in the picture.
✔
Wind the wire in the direction indicated
by the arrow on the spool as uniformly as
possible. Follow the maximum length
recommended for your equipment (6
meters for Master 500L/600 and 8 meters
for Master 700/800).
Advance and automatic cutting of
the nylon line
1 - With the equipment running:
✔
Slightly press the spool against the ground.
The nylon line will automatically be
released. The cutting blade fixed to the
protection device will limit the amount of
wire released.
✔
Press the spool against the ground as many
times as necessary.
✔
In order not to damage the equipment or
the protection device, only press the metal
part of the spool against the ground.
26
1
2 - You may want to carry out this operation
manually:
✔
Unplug the equipment.
✔
Press the metal part of the spool (1) with
one hand and with the other pull the
nylon line (2) in the necessary length. If
the wire exceeds the ideal length, it will
be cut by the blade fixed to the protection
device.
2
Fixing the extension cord to the
equipment
There is a locking system in the lower part of
the handle to facilitate usage and to prevent
the extension cord from being disconnected
from the wall outlet. To use this system, do as
shown in the figure below:
✔
Put the extension cord in hole (1).
✔
Pass the cord over the lock (2).
✔
Connect the equipment plug to the
extension cord (3).
3
1
2
1