General Safety Advice - Beper P206VEN440 Manual De Instrucciones

EN
Mini Mist Fan Use instructions

General safety advice

Read the operating instructions carefully before first use of the
appliance.
Read the following instructions carefully, since they give you useful
safety information about installation, use and maintenance and help
you avoid mishaps and possible accidents.
Remove the packing and make sure that the appliance is intact. The
elements of the packing (plastic bags, polystyrene, etc) do not have
to be accessible to the children, in order to preserve them from dan-
ger sources.
It is recommended not to throw these packing material in the dome-
stic waste, but to deliver them to the appropriate station of collection
or destruction refusals, asking eventually information to the manager
of the Sanitation Department of your own municipality.
This appliance is to be destined to its special purpose only.
Any other use is to be considered as improper and thus dangerous.
The manufacturer cannot be responsible for any damages deriving
from improper, wrong or incautious use.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Also make any dangerous parts unserviceable,
especially for children who could play with the ap-
pliance.
Description of the product Fig. A
1. Motor case
2. Battery case cover
3. ON/OFF button
4. Water tank
5. Mist handle
Operation
By using a Phillips screwdriver, remove the cover of the battery case; insert 2 AA type alkaline batteries (not
included), paying attention to the polarity indicated on the case. Replace the cover, and firmly fasten it back to
the motor case with the screwdriver.
To turn the fan on, press the ON/OFF button found on the upper part of the motor case; press the button again
to turn the fan off. For mist function, fill the tank with water up to the desired level (make sure not to overfill the
tank); put the tank back in place making sure it is firmly attached to the motor case and that it does not leak; press
the mist handle to spray water at your desire.
5