Idiomas disponibles
Idiomas disponibles
17
Technical Information
Use
Startup
R
S
P
If the pump is not connected, the display will be as follows:
NOTE
C
After pressing the START pushbutton, if the P1 connector is not in place with
NOTE
the link or the external interlock connections are open, the display will be as
shown in the following figure. Unplug the controller power cable and verify
the P1 connection according to the previous Section.
250/280
Plug the controller power cable into a suitable power source.
The display lights, and shows:
E
A
D
Y
O
F
T
The controller with the Soft Start mode allows the pump to ramp-
up to Normal speed slowly with a minimum ramp-up time of 75
seconds and a maximum of about 45 minutes. The Soft Start
mode is always operative as default mode. If it is necessary to
deselect this mode refer to the following paragraph.
If the Soft Start mode is deselected, the ramp-up will be done
within 75 seconds and the display changes as follows:
U
M
P
S
T
A
R
H
E
C
K
T
O
Turbo-V 70 PCB Controller User Manual / 87-900-871-01 (E)
F
O
R
S
T
A
R
R
E
A
D
T
B
U
C
O
N
N
P
U
M
L
O
C
A
T
Y
:
P
U
T
T
O
N
E
C
T
P
L
S
H
I
O
N
Capítulos
