Fork Preparation - Cervélo S3 DISC Manual De Instrucciones

FORK PREPARATION

A. Stem Cap + 5mm bolt
B. Headset Spacers
C. Bearing Cap
D. Compression Ring
E. Bearings
F. Fork Insert
G. Two-Part Epoxy
H. Mixing Stick
I. Isopropyl Alcohol Wipe
J. Sandpaper (120 Grit)
3
1. Apply grease to the bearing seats, and Install the upper & lower
A
2. Fit the fork into the head tube with the complete headset,
B
3. Apply the minimum pressure needed to ensure the assembly
C
4. Remove fork and clearly mark the fork steerer tube at a point 4mm
D
E
F G
1st Mark
I
H
J
headset bearings into the head tube.
required spacers, and the stem.
is fully seated. Mark the steerer tube at the top of the stem.
below the first mark. Take care to verify that this measurement is
correct as this defines the cut line for the steerer tube.
Do not exceed 50 mm maximum total spacer height,
including the bearing cap.
Avoid breathing the dust created during cutting carbon
composite materials.
2nd Mark /
Final Cut
A 2.5mm spacer under
the Stem Cap is advised
Max.
4mm