Function Introduction - Konix DRAKKAR STYRI Manual Del Usuario

A

4. FUNCTION INTRODUCTION:

4.1 Program Functions (without memory)
4.1.1 Introduction
1. Program source button: X/4, B/2, Y/1, A/3, LB/5, LT/7, RB/6, RT/8
2. Programmable button: Left Wing, Right Wing, Pedal of Gas, Pedal of Brake,
LS/11, RS/12, Gear Shift (LT/7,RT/8)
4.1.2 Program setup
1. Press Prog, Hold for 3 seconds until the green LED is on.
2. Press the programmable button, and the green LED starts blinking
3. Press program source button. The green LED is off. Program is set.
4.1.3 Clear single program
1. Press Prog, Hold for 3 seconds until the green LED is on
2. Press programmed button and the green LED starts blinking
3. Press programmed button again and the green LED is off.
Single programmed button is cleared
4.1.4 Clear all programs
1. Press Prog, Hold for 3 seconds until the green LED is on
2. Press START/10 and hold for 4 seconds. The green LED is off.
All of the programmed buttons are cleared. Default is restored
Note: All programs will be cleared after the wheel is power off, it means the
wheel does not have memory of program.
4.2 Wheel sensitivity adjustment
1. Press BACK/9+START/10, Hold for 3 seconds until green LED is on
2. Press BACK/9, Existing sensitivity will be displayed
3. Press BACK/9, Select sensitivity according to the circulation below:
Medium (Green LED flash)
High (Green LED Flash quickly)
Low (Green LED Flash slowly)
4.3 The pedals in digital mode have analog functions:
Performance: The harder the pedal is pressed, the larger value, the higher flashing
5. FOR USE WITH PC:
5.1 Switch of modes
1. Default X-INPUT, Back lit Red LED is on
2. Press and hold MODE for3 seconds, D-INPUT will activated and Red LED is on.
5.2 D-input installation:
1. Download the drivers from the www.konix-interactive.com website.