Installation - Whip Mix VeriWash Manual Del Usuario

VERIWASH User Manual

4. INSTALLATION

4.1 Place the Main Body (Base) on flat surface.
NOTE: The disposable clear plastic cover is already in place.
This is a disposable item and can be changed if it becomes
soiled with spilled resin or alcohol.
4.2 Place each Wash Container on the Main Body. Be sure each fits well.
4.3 CAREFULLY fill the Wash Container with 2.5 - 3.0 liter of Isopropanol.
NOTE: It is recommended to dedicate one container as the
first bath for the parts coming directly from the printer, and
the other container as a second bath, filled with fresh IPA
(ISOPROPANOL).
NOTE: Keep the Lid closed when the VERIWASH is not in use to
minimize the evaporation rate of the alcohol.
4.4 Use the Mesh Basket only to wash 3D printed parts not attached to the
printer build plate.
NOTE: To clean small 3D printed parts such as dies or single
crowns, there are two options as follows:
Put them into a 3" stainless steel tea ball infuser (not sold by
Whip Mix, can be purchased online), then insert into the mesh basket
as shown below.
For a 3D printer with a build plate size up to 180 mm x 90 mm (7.08"
x 3.54"), when not using the stainless steel tea ball infuser, keep the
printed parts attached to the build plate and use the Universal Build
Plate Jig as instructed in 4.5.
6
Whip Mix Corporation