Thrustmaster ENZO FERRARI WIRELESS Manual De Instrucciones página 2

WHEEL SETUP
1. Insert 4 AA (LR6) batteries into the battery compartment
base, making sure to respect the polarity indicated.
2. Slowly slide the removable wings
place.
3. Place the clamp screw
the underside of the wheel until firmly fixed into place.
Note: be careful not to over-tighten the clamp screw to avoid damaging the knee-top piece.
4. Connect the pedal connector cable
5. Set the channel selector switch
6. Connect the RF base station
must use an independent power supply for your Enzo Wireless wheel to operate properly).
7. Switch on the power by setting the channel selector switch
8. Switch on your PC.
onto both sides of the knee-top piece
into the hole in the knee-top piece and then screw the unit into the hole on
to the analog pedals .
on the RF base station
to your computer's USB port (if you are using a USB hub, your hub
2/6
located on the underside of the wheel
until firmly fixed into
to the A position.
on the wheel to the A position.