LaserLiner ThermoSpot-Vision Manual De Instrucciones página 15

Settings for measuring modes
8
In addition to the general system settings, other settings are possible speci -
cally for measuring mode. These settings are effective for following modes:
IR CAM, IR MEASURE, DEWPOINT, DATALOG. Therefore, check the speci c
setting before each measuring task.
Use the navigation buttons to select a corresponding mode from the start menu
and press "ENTER" to con rm. Press the "ENTER" button again to access the
settings of the measuring mode:
Set emissivity coef cient
Select the material type with
Emissivity human skin, ice/water, plastic, Wood. For an individual
emissivity coefficient select "E" and confirm with Enter.
(see Point 17)
Set the value with
To save and exit menu press the "ESC" button.
Alarm temperature, alert - temperature above
threshold
Alarm High
Set temperature or disable function with
To save and exit menu press the "ESC" button.
Alarm temperature, alert - temperature below
threshold
Alarm Low
Set temperature or disable function with
To save and exit menu press the "ESC" button.
Dual laser
Enable/disable laser with Laser
To save and exit menu press the "ESC" button.
Automatic trigger (dual laser)
Enable or disable with
continuously when enabled. A lock symbol appears next to
Auto mode
the battery indicator.
To save and exit menu press the "ESC" button.
Min/Max display
Enable or disable display with
Max/Min
To save and exit menu press the "ESC" button.
Average value/difference display
Enable or disable display with
Average/Dif
To save and exit menu press the "ESC" button.
Ambient temperature/relative humidity display
Ambient
Enable or disable display with
TEMP/%RH
To save and exit menu press the "ESC" button.
Dew point/wet-bulb temperature display
Dewpoint/wet-
Enable or disable display with
bulb
To save and exit menu press the "ESC" button.
Type-K display (only with Type-K sensor connected)
Type-K
Enable or disable display with
(see Point 14)
To save and exit menu press the "ESC" button.
Enable/Disable: Enable/disabled
/ . Concrete, glass,
/ .
/ .
/ .
/ .
/ . IR measurement takes place
/ .
/ .
/ .
/ .
/ .
ON/OFF: ON/OFF
ThermoSpot-Vision
GB 15