DeWalt D51430 Manual De Instrucciones página 21

Removing the trigger
• Disconnect the airline from the tool.
• Remove all fasteners from the magazine.
• Remove the rubber grommet (8) from the end of
the dowel pin (9).
• Remove the dowel pin.
• Remove the trigger assembly (10).
Fitting the trigger
• Insert the trigger assembly into the trigger cavity,
ensuring that the trigger spring (11) is properly
seated.
• Insert the dowel pin (9) through the tool frame,
contact trip guide and trigger assembly.
• Push the rubber grommet (8) onto the end of the
dowel pin.
Air fitting (fig. A)
These tools have a standard 3/8" pipe thread for the
air fitting (7).
• Wrap the male end of the fitting with Teflon tape
to prevent air leaks.
• Screw the fitting into the end cap and tighten firmly.
Loading the tool (fig. C)
• Lock the magazine latch (6) in the back position.
• Select an appropriate collated fastener stick.
See „Technical data".
• Place the collated fastener stick (s) onto the
magazine rail (11).
• Release the magazine latch by unlatching the
lever (12).
• Carefully slide the latch forward to press against
the fasteners.
Unloading the tool (fig. C)
• Lock the magazine latch (6) in the back position.
• Remove the collated fastener stick (s) from the
magazine rail (11).
Always disconnect the tool from the air
supply before loading or unloading
fasteners.
Adjusting the driving depth (fig. D)
The driving depth can be adjusted to the type of
fastener used.
• To reduce the depth, press the lock button (12)
and slide the slider (3) downward.
• To increase the depth, press the lock button (12)
and slide the slider (3) upward.
Trigger lock (fig. A)
This tool is equipped with a trigger lock-off switch
which prevents the tool from firing a fastener.
• To engage the trigger lock, push the switch (2) to
the right.
• To release the trigger lock, push the switch to the
center.
Instructions for use
Always observe the safety instructions
and applicable regulations.
Preparing the tool (fig. A)
• Drain all condensation from the air compressor
tanks and hoses.
• Lubricate the tool. See „Maintenance".
• Remove all fasteners from the magazine.
• Check if the contact trip (4) can move freely.
Do not use the tool if the contact trip
cannot move freely.
• Check that the pressure of the air supply is below
the maximum recommended operating pressure.
• Connect the air hose to the fitting on the tool.
• Check for audible leaks around valves and gaskets.
• Set the air pressure to the minimum required
operating pressure for your application.
Never use a tool that leaks or has
damaged parts.
Cold weather operation
When operating tools at temperatures below freezing:
• Keep the tool as warm as possible before use.
• Disconnect the airline from the tool.
• Put 10 to 15 drops of D
(or winter-weight pneumatic oil containing
ethylene glycol) into the air inlet.
• Set the air pressure to a maximum of 5.5 bar.
• Connect the air hose to the fitting on the tool.
• Load fasteners into the magazine as described
above.
• Actuate the tool 5 or 6 times into scrap lumber to
lubricate the o-rings.
E N G L I S H
WALT pneumatic tool oil
E
21