Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Cordless Spotlight Compressor with Emergency Car Starter
7. If the light or dial still does not brighten, turn off the light or dial, and
allow this unit to remain on the 12V socket for at least 35 minutes.
Remove it from the 12V and attempt to start the vehicle.
8. If the vehicle does not start, DO NOT attempt to start the engine more
that twice. Call a service center or tow truck.
Using as a DC 12V Power Source
•
The Cordless Spotlight Compressor's 12V DC Power Socket mimics the
12V socket of a vehicle.
•
Any accessory you would normally plug into your vehicle's 12V socket
(cell phone, camcorder, flashlight, radio, etc.) can be powered from
the compressor's 12V socket, using the compressor's built-in battery as
the power source.
•
This unit's 12V DC socket is center pin positive (+). Most 12V DC
accessories come with this configuration, but not all. Before connecting
any accessory to Wagan 2450's 12V socket, check the accessory
owner's manual for the polarity of the accessory.
•
If the accessory is center pin positive, simply plug it into the 12V
socket.
•
For the DC accessories that are NOT center pin positive, you must use
a DC to DC adapter (not included).
Using the Spotlight or the LED reading light
A. Spotlight: locate the on/off switch on the handle of the unit. Change it
from "O" to "I" position.
www.wagan.com
7
User's Manual—Read before using this equipment
B. LED Reading light: locate the on/off switch on the handle of the unit.
Change it from "O" to "II" position.
Note: The halogen and LED bulbs are not designed to be removed by
users. DO NOT attempt to change or modify them.
RECHARGING THE UNIT
Recharging from a 12V DC Source
(Car, Truck, Boar, 12V DC Charger)
Important: Do not leave this unit plugged into the 12V socket when the
vehicle is not running as it may drain power from the car battery. When
charging in a vehicle, leave the engine running or charge while driving.
1. Connect the DC adaptor in the unit's charging socket.
2. Connect the other end of the adaptor in the vehicle's 12V socket
(cigarette lighter) and let it charge for about 8 to 10 hours.
Recharging from an AC Power Source
1. Connect the AC adaptor in the unit's charging socket.
2. Connect the other end of the adaptor to any household wall outlet.
Let the unit charge for about 25 to 27 hours.
Note: The Wagan Cordless Spotlight Compressor should be charged at least
once every 4 months regardless of usage to maintain charge. Draining a
lead acid battery completely will damage the battery. This is not covered by
the warranty if this occurs. Led acid batteries do not have memory, so the
unit can be charged periodically.
©2010 Wagan Corporation
All Rights Reserved
Wagan and wagan.com are trademarks used by Wagan Corporation
8
Tabla de contenido
