Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Cordless Spotlight Compressor with Emergency Car Starter
Use and Care
•
Check for misalignment or binding of moving parts, breakage of parts,
and any other condition that may affect the operation of the unit. If
damaged, have the unit serviced before using.
•
During operation, the unit may feel warm. Discontinue its use if it
becomes too hot.
•
Battery operated products with integral batteries must be recharged
only with the specified charger for the battery. A charger that may be
suitable for one type of battery may create a risk of fire when used
with another battery.
Service
•
The battery is not intended to be removed from the unit by the user.
•
The halogen and LED bulbs are not designed to be removed by users.
Do not attempt to change or modify them.
•
The service of this unit must be performed only by qualified repair
personnel. Service or maintenance performed by unqualified
personnel may result in risk of injury.
DANGER SHOCK HAZARD! Keep battery charger and adapter away from
water and other liquids. Never operate if cord is damaged or product is not
working properly. Unplug when not in use.
SPECIFIC SAFETY RULES
•
The Spotlight Compressor needs to be charged before the first use.
See the section "Recharging the unit" for more details.
www.wagan.com
3
User's Manual—Read before using this equipment
•
Before attempting to start a vehicle, this unit must be removed from the
vehicle's 12V socket. See the section "Using the Jumper" for details.
•
The unit is designed to recharge 12V batteries with a low voltage
between 10.4 and 10.5 volts. If the vehicle's battery is severely
drained, call a service center or tow truck.
•
Do not attempt to reverse the polarity of the unit. 25A fuses are used
in a protection system which regulates the discharge and recharge of
this unit.
•
For optimum performance, store in temperatures between 32°F-110°F
(0°C-43°C). Temperatures below 45°F (7°C) and above 85°F (30°C)
will require at least an additional 10 minutes of recharging before
starting engine.
•
Car Alarms: If you have a car alarm, put it into "valet mode" before
attempting to use the unit. Many popular car alarm models cut off the
power to the vehicle's electrical system. The unit will not work while
this type of alarm is engaged.
OPERATION
Using the Air Compressor
CAUTION: Check item to be inflated for manufacturer's recommended
maximum inflation pressure. Avoid over inflation. Most tires are properly
inflated between 24-35 PSI. Some truck and bicycle tires require 40 PSI
or more.
A. To Inflate Tires:
1. Open the air hose storage compartment (lifting up the spotlight
lantern) and extend the air hose.
©2010 Wagan Corporation
All Rights Reserved
Wagan and wagan.com are trademarks used by Wagan Corporation
4
Tabla de contenido
