Wall Mounting; Cleaning And Maintenance - Duronic HV120 Manual De Instrucciones

Using The Turbo function
This is operated by means of the switch with the fan symbol beside it. The fan
will only operate with the thermostat is in the "ON" position and can be used
when the heating elements are "ON" to blow warm air into the room.

Cleaning And Maintenance

For maximum efficiency, clean the fan regularly.
- Switch power switches to "OFF" position, unplug and allow the heater to
cool.
- Wipe surfaces with a soft cloth. Do not use detergent or abrasives as this will
scratch the surface.
- Ensure the intake grills free front dust, as this will reduce the airflow. Light
accumulated dust can be removed with soft cloth or vacuum cleaner.
- Allow surface to fully dry before using the heater again.
Maintain The Life Of Your Heater
- Avoid knocking or scratching the heater.
- Do not in dusty environment.
- When not in use cover heater and store in clean, cool and dry area.
8

Wall Mounting

The heater is supplied with 4 sets of fixing brackets, screws and plastic wall
plugs to enable it to be mounted onto a wall if required.
If the heater is intended to mount onto the wall, the feet should not be fitted.
The position must be chosen carefully. It must not be in front of or below a
power socket and must not be below a shelf, curtains or any other obstruction.
Also refer to the safety instructions.
Having decided on the location of the heater it is necessary to drill 2 fixing
holes with the distance of 380mm on a horizontal line at a minimum height
of 400mm from the floor, at a minimum distance of 600mm from ceiling and
300mm from side wall (see bellow) . Allowance must be made for any floor
coverings, carpet etc and if any skirting boards are present, the fixing holes
must be a minimum of 400mm above the top edge of the skirting board.
Using the plastic plugs and fixing screws provided, attach 2 of the fixing
brackets to the wall. The other pair of fixing brackets must be attached to the
base of the heater using the feet retaining screws so that the brackets project
out at the rear of the heater and space the bottom edge away from the wall.
If required, these brackets may also be secured to the wall using the
remaining fixing screws and plastic wall plugs.
9