General Safety; Electrical Safety - Duronic HV120 Manual De Instrucciones

General Safety

- Do not cover, restrict the air inlet/outlet or use the appliance to dry clothes.
- Do not use without feet attached.
- Only use in the upright position on a flat level surface.
- Make sure that children and pets are closely supervised when the heater is
in use.
- Do not use the appliance near flammable or heat sensitive items
- Do not position directly next to power sockets, shelving or other obstructions
to airflow.
- Do not use the heater in the immediate surroundings of a bath, a shower, or
a swimming pool.
- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or metal capabilities, or lack of experience
and knowledge, unless they have been given supervisions or instruction
concerning use of the appliance by a person responsible for the safety.
NOTE
- For maximum benefit, close windows and doors when the heater is in use.
- Do not cover the ventilation holes as this will cause overheating and will
activate the cut out.
DO NOT plug the heater into an extension lead or adapter as the heater is too
powerful. Using an extension lead or adapter with the heater is a fire hazard and
may cause damage to the device the the user.

Electrical Safety

- For indoor use only.
- Switch off and unplug when not in use.
- Do not use if the cord is damaged.
- No not use heater in humid or wet environments
- If the appliance cord is damaged, it must be replaced by an electrician or
similarly quality person to avoid hazard.
6
Assembly
- Carefully turn the radiator on it's side to fit the feet
- Position each foot as shown in fig1. and secure using the self tapping screws
provided
- Two screws are required for each foot and this unit must not be used without
the feet firmly attached.
||: 1250W
Fan Switch
|: 750W
Thermostat
To Use
- Turn the heater to the "OFF" position before plugging in.
- The operating temperature is selected by a combination of the heater
switches and thermostat. The hottest setting will be when the heater switches
are both on and the thermostat is turned to "Maximum".
- To determine the correct working temperature for your conditions, turn the
heater to "High" and the thermostat to "Maximum" when the room has reached
the required temperature turn the thermostat slowly to the left until the
temperature is off. The temperature will now be kept constant.
- If you want to lower the operating temperature select the heater switch only
and repeat the above procedure.
- The heater is fitted with an automatic cutout in the event that it overheats.
If this activates, turn the heater to the off position and unplug. Allow the
heater to cool and remove anything restricting the airflow before using the
heater again. If the automatic cut out operates repeatedly contact a quantified
electrician for advice.
7