IPC PW-C25 G.Power Manual Del Usuario página 16

- Disconnect water supply hose from machine and
water supply mains.
9
ACCESSORIES
Variable nozzle
The nozzle (12 - Fig.1) can be regulated in a
continuous manner, by rotating the regulation
bushing, changing it from a pinhole jet (Fig.12) to
a flat jet and viceversa.
It can be used at either high or low pressure by
shifting the head in a longitudinal sense according to
the direction of the arrow on the head itself (Fig. 13).
ADDITION OF DETERGENT
The detergents must not be allowed to
dry on the object to be cleaned.
The product is fitted with two detergent tanks.
Thedetergent adjustment knob (Fig. 15) is used to
switch thesuction between detergent tanks (Fig. 16)
and increase/de-crease detergent flow.
Fill the machine tanks with detergent (Fig. 14) taking
care to dilute it according to the instructions. To fa-
cilitate the filling and emptying operations, the tanks
can be removed from their housings.
Winder kit
The rotation sense for the winding of the high pres-
sure hose is only permitted in a clockwise direction.
(fig. 17). It is possible to prevent rotation by using the
lever (1) situated on the back of the handle (Fig. 18)
REGULATING PRESSURE
This chapter concerns only those models pro-
vided with the "pressure regulating" device.
The pressure regulator, fig. 20, allows the operator
to adjust the working pressure. When knob C is
turned in an anti-clockwise direction (B) (minimum),
the working pressure is reduced.
10
MAINTENANCE , REPAIRS
AND STORAGE
Before undertaking any work
on the appliance always de-
tachthe plug from the power
socket
Undertake only the maintenance operations descri-
bed in the user instructions.
Contact the Technical Assistance service for all other
interventions.
Use only original spares.
Should the power cable be damaged, it must be
replaced by a cable or a set of special cables avai-
lable from the manufacturer or its assistance service.
The pins and joints of the connection cables of the
electrical system must be protected against accidental
water sprays.
Cleaning/inspecting the strainer
Expose the strainer (2 - Fig.19) in the machine water
inlet connection by removing the inlet connector
(1). The strainer (2 - Fig.19) can be easily removed
with longnose pliers. Rinse and replace. If damaged
replace.Never use the pressure washer without the
straineror a damaged strainer.
STORAGE
Store the appliance in premises protected against
freezing conditions.
If freeze protection is not guaranteed, suction a
glycol based anti-freeze into the pump, as for cars
- Immerse the water pipe into the container of anti-
freeze
- Immerse the gun without the sprayer nozzle into
the same container
- Insert the appliance with open gun
- Activate the gun until an even jet is obtained.
Store the rest of the anti-freeze in a closed container.
Treatment of waste from electric/electronic
equipment
Dispose of the product in accordance with current
regulations concerning differentiated waste disposal
in dedicated waste disposal areas. Do not treat as
simple urban waste.
For any information please contact the manufacturer
at the address specified in the user manual.
The product complies with the requirements
of the new directives introduced for the envi-
ronmental safeguard and must be disposed
of appropriately at the end of its life cycle.
16