Troubleshooting - Midland ENERJUMP WORK Manual Del Usuario

TO CHARGE/POWER SUPPLY A NOTEBOOK (19V)
1. Plug the supplied cable for Notebook to the 19V/3.5A output port
2. Choose the appropriate connector for your Notebook and connect it to the cable and then to the
Notebook.
3. Press the switch button of Enerjump Work to charge/power supply.
TO CHARGE/POWER SUPPLY 12V DEVICES
The 12V electronic devices can be powered/charged through the 12V/10A Output port.
LED FLASHLIGHT
Press the switch button for 3 seconds to turn on the fl ashlight. Press it again slightly and the fl ashlight will
light up in 4 diff erent modes in sequence (normal, strobe, SOS, off ).
TROUBLE SHOOTING
PROBLEM
No response when the device is
turned on
Enerjump Work is a bit hot while
charging a Notebook
BEEP, BEEP BEEP, BEEP
CAUSES
Low voltage protection
Enerjump Work
The charging current is a bit high
(3.5A)
CORRECTIVE ACTION
of Plug the adaptor into the 14V
/ 1A Input port to recharge the
device
Remove the battery from your
Notebook and recharge it /sup-
ply power directly; or disconnect
Enerjump Work from your No-
tebook and try again when it is
cool
11