Midland ENERJUMP WORK Manual Del Usuario página 14

STARTING A VEHICLE
1. Make sure that Enerjump Work is properly charged (the number of the indicator lights must be not
less than 3).
2. Turn off all the accessories on the vehicle.
3. Connect the clamps' circuit to the socket "JUMPER CABLE" of Enerjump Work and make sure that
the cable indicator is off .
4. Connect the red battery clamp to the vehicle's positive (+) battery terminal and connect the black
battery clamp to vehicle's negative (-) battery terminal. Warning: pay attention to the polarity!
5. Press the BOOST key on the clamps' circuit; then you will fi nd on the following options:
- Green led on: the connection is correct and the circuit is working. You can turn on the engine.
- Red led on and buzzing: incorrect connection. Remove the cable (circuit) from Enerjump Work
and try again. Then turn on the vehicle.
- Flashing green led and buzzing: the battery of your vehicle has a low voltage. Push the "BOOST"
key; the green led lights up. Turn on the engine within 30 seconds.
- All leds are off and no buzzing: the battery of your vehicle is probably dead. Make sure that the
connection is correct and then press the "BOOST" button: the green led lights up. Start the
vehicle within 30 seconds.
6. If the engine starts, disconnect the red and black clamps from the vehicle's battery terminal within
30 seconds.
7. Leave the vehicle's engine running for a few minutes.
8. If the vehicle does not start at a fi rst trial, wait 1 minute and repeat the procedure.
CHARGING A MOBILE DEVICE WITH USB PORT
Plug the USB cable to one of the USB output ports .
Connect the other end of the cable to your device. The charging lights will be on when charging.
10
BEEP, BEEP BEEP, BEEP