Rollplay 12V UPRIDER Manual De Instrucciones página 5

WARNING
WARNING
TO AVOID SERIOUS INJURY
1. Continuous adult supervision required and adult assembly only.
2. This vehicle is not suitable for children under 6 years due to special skill
and practice are required.
3. Plastic bags must be kept away from children to avoid suffocation.
4. Never use near motor vehicles, streets, roadways, alleys, swimming
pools, hills, steps driveway, sloped driveways inclines , motor ways
,uneven road and any obstacles in the path
5. Only one child should ride at a time.
6. Children should always wear shoes when riding.
7. Never ride the vehicle outside at night.
8. Never use in wet weather.
9. Maximum user weight is 50kg.
10. There are additional hazards of using the vehicle in areas other than
private grounds.
11. Make sure to wear a safety helmet and protective equipment to avoid
any possible injury.Not to be used in traffic.
12. The vehicle must be used with cautions since skill is required to avoid
falls or collisions causing injury to the user and third parties.
13. Periodically check the hardware and tighten if necessary .Replace
worn or broken parts immediately.
14. Keep away from fire.
15. Battery ,charger, electric wire plug, enclosure and other parts should
be periodically check for damage .if have any damage, need to repair
before use.
16. Because products do present potential hazards plainly associated with
their use, it is well recognized the need for exercise of parental
responsibility in selecting riding products appropriate to the age of a child,
or parental supervision in situations in which children of various ages may
have access to the same riding products, is important. Not every product is
appropriate for every age or size of child, and different age recommenda-
tions are found within this category of product which are intended to reflect
the nature of the hazards and the expected mental or physical ability, or
both, of a child to cope with the hazards
17. Riding any electric product can be a hazardous activity. Certain
conditions may cause the equipment to fail without fault of the
manufacturer. Like other electric products, the up-rider can and is intended
to move, and it is therefore possible to lose control, fall off and/or get into
dangerous situations that no amount of care, instruction or expertise can
eliminate.
WARNING
1. Do not mix old and new batteries.
2. Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
3. Only use the batteries specified by the manufacturer.
4. Non-rechargeable batteries are not to be recharged.
5. Rechargeable batteries are only to be charged under adult supervision.
6. Be sure to insert the batteries correctly and always follow the vehicle
and battery manufacturer's instruction.
7. Weak or exhausted batteries are to be removed from the vehicle.
8. Do not short-circuit the supply terminal.
9. The charger is not a toy.
10. Exhausted batteries are to be removed from the vehicle
11. Choking hazard small parts, not for children under 6years.
12. Risk of fire – No user serviceable parts. They are not intended for use
at elevations greater than 2000 m above sea level.
13. Prolonged Exposure to UV rays, rain and the elements may damage
the enclosure materials.
14. Store indoors when not in use. Only use
HK-AX-138A100-GB/HK-AX-138A100-EU charger.
15. The vehicle must only use with the recommended charger.
16.The vehicle need to be stored in a dry environment.
17. The vehicle should be used on a flat surface.
18. Avoid streets and surfaces with water, sand, gravel, dirt, leaves and
other debris.
19. Recharging the battery and using the vehicle should be carried out at
0--30℃ temperature.
20. Discarded batteries must be stored in a designated recovery area and
cannot be discarded carelessly.
CHARGING YOUR VEHICLE:
1. Charge the Battery for 12 hours before using this vehicle for the first
time.
2. Connect the terminal of battery and charger, and then plug the charger
into the 220V AC mains socket.
3. After 1-2 hours of use please charge for 8-12 hours but do not exceed
20hours of charging.
4. If the vehicle is moving slower than usual please recharge immediately
for 8-12hours.
5. If you have not used the vehicle in quite some time then please fully
charge the battery and charge once every 3 months to extend the battery
life.
6. If the charger is hot (under 71℃) while charging, that's normal.
7. The charger connector must not be put near water or it will short circuit.
8. The Car must only be charged with the charger supplied otherwise the
car may be damaged.
9. Only Adults must charge the battery.
10. Only batteries of the same or equivalent type as recommended are to
be used.
11. Batteries are to be inserted with the correct polarity.
12. Damaged Batteries must be removed from the car.
13. The power supply terminals are not to be short circuited.
14. Do not mix old and new batteries.
15.Keep children away when charging
Fig 1:
Handlebar Mounting:
1. Insert the upper handlebar assembly into the lower handlebar
assembly in the direction indicated in the picture. A "click" sound can be
heard when it is inserted in place.
2. Then set the whole handlebar assembly onto the fixing rod on the
main frame. Again a "click" sound will indicate the connection is done.
Handlebar Disassembling:
Press the disassembling button at the lower part of the lower handlebar
assembly and meanwhile pull the whole handlebar assembly up to
remove it from the main body. Select an appropriate screwdriver and
insert it into the disassembling hole at the upper part of the lower
handlebar assembly to force down the spring pin in the hole and
meanwhile pull the upper handlebar assembly up.
Use of Handlebar:
The height of the handlebar can be adjusted according to the tallness of
the driver. First press down the button in the front of the handlebar and
meanwhile turn the handlebar. The handlebar can be adjusted in 360
degrees with eight directions.
Fig 2:
Battery Wiring:
After installing the handlebar, the power supply should be connected.
The battery is located under the foot board. Press the foot board
disassembling button and pull the foot board upward to take it off. First
connect tightly the connector of the battery with the connector of the
main body, then connect tightly the connector of the foot board with the
connector of the main body.
Fig 3:
Battery Recharging:
When the battery is running low, the vehicle will beep to remind the user
to recharge the battery. The socket for recharging is located above the
power switch. Before recharging, its cover must be pulled open. Insert
the plug of the charger. And then turn on the power for recharging. After
completion of recharging, put the socket cover back to its position.
Notes: Make sure that the recharging plug is fully inserted into the
socket. In the course of recharging, the power switch shall be in the
OFF position. Do not use the vehicle during recharging!
Fig 4:
Foot board assembly
According to the direction of arrow, insert the two snaps into the groove
and press the back of foot board . The assembly is finished until you
hear the click sound. Note: While the assembly, do not hold down the
wires.
Fig 5:
Installation and Usage Instructions Preparation:
Select an appropriate place before driving for the first time. Such place
can be either indoor or outdoor as long as it is at least 4×4 m (16 sq m).
The ground shall be flat but not too wet, slippery, smooth or rugged.
There shall be no steps, obstacles, motor vehicles, bicycles, pets,
infants or other distracting objects on the site. You need an instructor
(coach) who is experienced in driving and has read the warnings/pre-
cautions in this manual to aid you according to the instructions. Make
sure to wear the equipment including a helmet to protect the wrists,
hands,knees and head to avoid any possible injury.
Fig 6:
1. Power-on: Press the power switch (its indicator will turn on) to
connect the power supply. Please keep the foot board basically level
when turning on the power.
2. Get-on: When using the vehicle for the first time, the driver can ask a
caregiver to help hold it stable. The driver stands on the rear part of the
vehicle with both hands holding the handlebar. Please put the operating
rod straight (in a basically idle condition), and adjust the handlebar until
it remains level. Look straight ahead. First, put one foot onto the foot
board. Move the body's weight slowly onto the foot board and lift the
other foot. Try best to avoid moving the handlebar laterally, raise the
other foot slowly off the ground and put it onto the foot board. Stay calm
and relaxed, and watch forward.
The sequence of postures for getting on is shown below:
3. Driving: The driver should manipulate this vehicle with his/her body
posture rather than with the accelerator and brake. In this way he/she
will feel more comfortable and responsive in driving. When the driver
stands onto the vehicle and leans forward, the main body will control the
wheels automatically to drive the vehicle forward; or leaning backward to
back the vehicle. Turn the handlebar left/right to drive the vehicle
leftward/rightward.
Back Stop Forward Left Right