BH FITNESS H1055N Instrucciones De Montaje página 10

FITTING THE MONITOR
Remove the screws (25) from the back
of the monitor, then place the monitor
on top of the main post in the direction
of the arrow, Fig.6, making sure not to
pinch any of the cables. Refit the
screws and tighten,
handgrip terminal (26) to the conector
(32) at the back of the monitor and the
feedback terminal (9) to the conector
(30), as shown in Fig.6.
FITTING THE PEDALS
The assembly instructions for the pedals
must be followed to the letter, fitting
these incorrectly could damage the
screw thread on either the pedal or the
crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal (29), marked with
the letter (R), screws onto the right-hand
crank, also marked with an (R), in a
clockwise direction. Tighten securely,
Fig. 7.
The left-hand pedal (28), marked with
the letter (L), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely, Fig.7.
Once the pedals have been fitted, insert
the end of the pedal clip (A) into the slot
on the pedal (B) adjusting it to your
footwear on the ledge of the pedal (C),
Fig.7.
connect
direction. Tighten
EXERTION SETTINGS.
To provide an even level of exertion
during
equipped with a tensioning control
(100), located on the handlebar stem,
offering various exertion settings, Fig.3.
the To increase pedal resistance turn the
tensioning control (100) clockwise (+)
until the exertion level best suits your
exercise requirements. To reduce pedal
resistance turn the tensioning control
(100) anticlockwise (-).
LEVELLING.
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This can
be achieved by screwing the adjustable
feet (46) up or down, as shown in Fig.8.
MOVEMENT & STORAGE
The unit is equipped with wheels (40) to
make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen position,
by lifting the rear of the unit up slightly
and pushing it, as shown in Fig.9. Store
your unit in a dry place, preferably not
subject to changes in temperature.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
10
exercise, this appliance is